Acura NSX 1991 Manual page 806

Main Menu
Safety Indicator
Indicator Input Test
SRS components are located in this area. Review the SRS
component locations, precautions, and procedures in the
SRS section (24) before performing repairs or service.
Remove the dashboard lower cover, dashboard lower
pad and instrument panel. Disconnect the connector "A"
(30-P) from the gauge assembly (see page
('91-'92)).
Inspect the connector and socket terminals to be sure they
are all making good contact,
If the terminals are bent, loose, or corroded, repair
them as necessary, and recheck the system.
If the terminals look OK, make the following input
tests at the connector.
– If a test indicates a problem, find and correct the
cause, then recheck the system.
– If all the input tests prove OK, the control unit
must be faulty; replace it.
Table of Contents
23-127 ('93-'96)
CONNECTOR "A"
YEL GRN/BLK
ORN/WHT
BLK
BLK/WHT
View from wire side
BLU
RED/YEL
RED/YEL
GRN/RED
GRN/BLU
CONNECTOR "B"