Main Menu
Driveshafts
Removal
6.
Remove the wheel sensor from the knuckle and the
rear of the lower arm, then secure the wheel sensor
wire to the suspension arm.
NOTE:
• Do not disconnect the wheel sensor.
• Avoid twisting the wires when reinstalling the
wheel sensor.
7.
Disconnect the parking brake cable from the body.
Corrosion resistant bolt
8 mm FLANGE BOLTS
22 N-m (2.2 kg-m, 16 Ib-ft)
WHEEL SENSOR
6 mm BOLT-WASHER
10 N-m (1.0 kg-m, 7 Ib-ft)
8.
Remove the flange bolt, then disconnect the toe
control arm from the body.
Corrosion resistant bolt
TOE CONTROL ARM
Table of Contents
PARKING BRAKE CABLE
8 mm BOLT-WASHER
22 N-m (2.2 kg-m, 16 Ib-ft)
FLANGE BOLT
12 x 1.25 mm
95 N-m (9.5 kg-m, 69 Ib-ft)
9. Hold the damper lower mount of stabilizer link with
a wrench, and remove the damper mounting nut.
10. Hold the ball pin of the stabilizer link with a hex
wrench, and loosen the self-locking nut.
Corrosion resistant nut
DAMPER MOUNTING NUT
12 x 1.25 mm
Replace.
95 N-m (9.5 kg-m, 69 Ib-ft)
STABILIZER LINK
11. Remove the self-locking nut, then remove the
stabilizer link from the stabilizer bar and knuckle.
Corrosion resistant nut
REAR DAMPER
STABILIZER LINK
WRENCH
HEX WRENCH
SELF-LOCKING NUT
12 x 1.25 mm
Replace.
85 N-m (8.5 kg-m, 61 Ib-ft)
SELF-LOCKING NUT
12 x 1.25 mm
Replace.