Acura NSX 1991 Manual page 354

Main Menu
Transmission Assembly
Installation
20. Install the right driveshaft onto the intermediate shaft.
21. Install the lower control arm to the side beam (see
CAUTION: Align the reference marks on the adjusting bolt, adjusting cam and lower control arm.
22. Install the damper fork bolt (see
23. Install the toe control arm to the side beam (see
CAUTION: Make sure that the arrow marks on the toe control arm are aligned.
24. Install the wheel sensor wire clamp and parking brake cable holder.
Corrosion resistant bolt/nut
8 x 1.25 mm
22 N-m (2.2 kg-m,
16 Ib-ft)
PARKING BRAKE
CABLE HOLDER
FLANGE BOLT
12 x 1.25 mm
95 N-m (9.5 kg-m, 69 Ib-ft)
TOE CONTROL ARM
SELF-LOCKING NUT
Replace.
14 x 1.5 mm
125 N-m (12.5 kg-m, 90 Ib-ft)
25. Install the front exhaust pipe A.
26. Install the rear beam rod.
27. Install the parking brake cable holders on the rear beam rod.
SELF-LOCKING NUT
Replace.
10 x 1.25 mm
34 N-m (3.4 kg-m, 25 Ib-ft)
EXHAUST
PIPE A
GASKET
Replace.
REAR BEAM ROD
10 x 1.25 mm
60 N-m (6.0 kg-m
43 Ib-ft)
Table of Contents
section
section 18).
section
SELF-LOCKING NUT
Replace.
12 x 1.25 mm
85 N-m (8.5 kg-m, 61 Ib-ft)
ADJUSTING CAM
ADJUSTING BOLT
GASKET
Replace.
8 x 1.25 mm
SELF LOCKING NUT
22 N-m (2.2 kg-m,
Replace.
16 Ib-ft)
10 x 1.25 mm
55 N-m (5.5 kg-m, 40-lb-ft)
18).
18).
DAMPER
SELF-LOCKING NUT
FORK BOLT
Replace
12 x 1.25 mm
95 N-m (9.5 kg-m, 69 Ib-ft)
WHEEL SENSOR WIRE CLAMP
LOWER CONTROL ARM
SELF-LOCKING NUT
Replace.
14 x 1.5 mm
125 N-m (12.5 kg-m, 90 Ib-ft)
Corrosion resistant bolt/nut
PARKING BRAKE CABLE
HOLDERS
12 x 1.25 mm
95 N-m (9.5 kg-m, 69 Ib-ft)
10 x 1.25 mm
60 N-m (6.0 kg-m, 43 Ib-ft)
6 x 1.0 mm
10 N-m (1.0 kg-m, 7 Ib-ft)
8 x 1.25 mm
22 N-m (2.2 kg-m, 16 Ib-ft)