Table of Contents
Advertisement
Main Menu
Door Mirror Test
1.
Remove the door panel, and carefully remove the
plastic cover (see
section
2.
Disconnect the power mirror 3-P connector.
3.
Test actuator operation:
TILT UP:
Connect battery power to the No.
3 terminal and ground to the No. 2
terminal.
TILT DOWN:
Connect battery power to the No.
2 terminal and ground to the No. 3
terminal.
SWING LEFT:
Connect battery power to the No.
2 terminal and ground to the No. 1
terminal.
SWING RIGHT: Connect battery power to the No.
1 terminal and ground to the No. 2
terminal.
4.
If the mirror fails to operate properly, replace it.
Table of Contents
20).
3-P CONNECTOR
View from terminal side
Door Mirror Replacement
1.
Remove the door panel, and carefully remove the
plastic cover (see
section
2.
Disconnect the 3-P connector.
DOOR MIRROR
3-P CONNECTOR
3.
Remove the two mounting nuts while holding the
mirror.
4.
Install in the reverse order of removal.
20).
MOUNTING NUTS
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
