Main Menu
Table of Contents
Rear Hatch Glass Molding
Replacement
CAUTION:
• Wear gloves to replace the molding.
• Do not damage the glass and defroster grid lines.
1.
Remove the rear hatch assembly (see page 20-64).
2.
Place the rear hatch assembly on its surface as
shown.
CAUTION: Avoid setting the glass on its edges;
small chips may later develop into cracks.
3.
With a helper holding the rear hatch assembly,
carefully cut off the molding.
4.
Turn the glass over, then cut the outer side rubber
portion
of the molding.