Acura NSX 1991 Manual page 586

Main Menu
15. Let the adhesive dry for at least one hour, then
spray water over the windshield and check for
leaks. Mark leaking areas and let the windshield
dry, then seal with urethane windshield adhesive.
NOTE:
Let the car stand for at least four hours after
windshield installation. If the car has to be used
within the first four hours, it must be driven
slowly.
Keep the windshield dry within the first hour
after installation.
Check that the ends of the front pillar retainer
are set under the air scoop.
16. Reassemble all removed parts.
Table of Contents
Rear Window
Removal
CAUTION:
Wear gloves to remove and install the rear window.
Since the rear window is double glazed glass with the
Inner glass (interior-side) larger than the outer glass,
care should be taken not to damege the edge of the
inner glass when removing the outer glass.
1.
To remove the rear window, first remove:
Seats (see page 20-39('93-'96),('91-'92)
Center pillar trim panel (see page 20-38)
('93-'96),37('91-'92)
Rear upper trim panel (see page 20-38)
('93-'96),37('91-'92)
Rear hatch assembly (see page
2. Remove the weatherstrip.
3. Disconnect the rear defogger sub-harness and
ground cable/antenna lead, then remove the
grommets.
WEATHERSTRIP
DEFOGGER SUB-
HARNESS
SPECIAL BOLT
ANTENNA
LEAD
GROUND
CABLE
20-64('93-'96),53('91-'92)
GROMMET
(cont'd)