Acura NSX 1991 Manual page 127

Main Menu
Engine Block
Illustrated Index
Lubricate all internal parts with engine oil during reassembly.
NOTE:
• Apply liquid gasket to the mating surfaces of the
left side cover and oil pump case before install-
ing them.
• Use liquid gasket, part No. 08718-0001.
DRIVE PLATE (A/T)
Check for cracks.
SPECIAL WASHER
12 x 1.0 mm
75 N-m (7.5 kg-m, 54 Ib-ft)
Torque sequence, page
12 x 1.0 mm
105 N-m (10.5 kg-m. 76 Ib-ft)
Torque sequence, page
CRANKSHAFT OIL SEAL
Installation, page 7-18
Replace.
SPECIAL BOLT
6 x 1.0 mm
12 N-m (1.2 kg-m,
9 Ib-ft)
Replace.
Table of Contents
COVER
7-6
7-6
COVER
FLYWHEEL (M/T)
Runout, section 12
DOWEL PINS
LEFT
SIDE COVER
Apply liquid gasket
to mating surface.
If the bottom of the oil pan is deformed, it should
be repaired or the oil pan should be replaced re-
tain proper clearance between the screen and
the bottom.
6 x 1.0 mm
14 N-m (1.4 kg-m, 10 Ib-ft)
OIL PAN
• Do not deform
the bottom.
• Refer to page 8-10
when installing.
6 x 1.0 mm
12 N-m (1.2 kg-m,
9 Ib-ft)
OIL SCREEN
O-RINGS
Replace.
DOWEL PINS
OIL PASS
PIPE/JOINT
OIL PUMP
Overhaul, page
Removal/Inspection,
page
Apply liquid gasket
to mating surface.
OIL PAN GASKET
Replace
BAFFLE PLATE
6 x 1.0 mm
12 N-m (1.2 kg-m, 9 Ib-ft)
CRANKSHAFT
OIL SEAL
Installation, page
Replace.
SPECIAL BOLTS
8-7
8 x 1.25 mm
22 N-m (2.2 kg-n
8-8
16 Ib-ft)
Replace.
SPECIAL BOLTS
6 x 1.0 mm
12 N-m (1.2 kg-m, 9 Ib-ft)
Replace.
O-RING
Replace.
8-9