Acura NSX 1991 Manual page 673

Main Menu
Engine Cover/Roof Cover
Removal
NOTE:
• Take care not to scratch the body.
• Open the rear hatch.
1. Open the engine cover, and support it with the sup-
port rod. Disconnect the roof holder switch connec-
tor, remove the nut, then remove the ground wire.
NOTE: If necessary, remove the roof switch sub-
harness.
ROOF HOLDER
SWITCH
NUT
CONNECTOR GROUND
WIRE
Table of Contents
ENGINE COVER
SUPPORT
ROD
GROMMET
HARNESS
CLIP
CONNECTOR
ROOF HOLDER SWITCH
SUB-HARNESS
2. Remove the support rod from the engine cover.
Remove the bolts, than remove the engine cover.
ENGINE COVER
EDGE CUSHIONS
ENGINE COVER
HINGE
3. Installation is the reverse of the removal procedure.
NOTE:
• Make sure the roof holder switch connector is
connected properly.
• If necessary, turn the engine cover edge cush-
ions to make the engine cover fit flush with the
body.
ENGINE COVER
ENGINE COVER
EDGE CUSHIONS
BOLTS
6 x 1.0 mm
10 N-m (1.0 kg-m,
7.2 Ib-ft)
CORROSION RESISTANT BOLT