Main Menu
19. Carefully lower the glass until you can see its
mounting bolts, then remove them. Pull the glass
out through the window slot.
NOTE:
• Lower the glass by connecting a 12 V battery to
the power window motor (see
• Scribe a line around the mounting bolts to show
the original adjustment.
GLASS
GLASS GUIDE
GLASS
20. Remove the locknuts, then remove the front glass
guide.
NOTE:
• Hold the adjusting bolt with a hex wrench when
removing the locknuts.
• Scribe a line around the locknuts to show the
original adjustment.
FRONT GLASS GUIDE
Table of Contents
section
23).
GLASS
MOUNTING BOLTS
6 x 1.0 mm
8 N-m (0.8 kg-m,
5.8 Ib-ft)
CORROSION RESISTANT
BOLT
LOCKNUT
LOCKNUTS
8 x 1.25 mm
22 N-m (2.2 kg-m,
16 Ib-ft)
21. Remove the mounting bolts and loosen the motor
mounting
bolts,
assembly through the window slot.
NOTE:
• Scribe a line around the mounting bolts to show
the original adjustment.
• Take care not to bend the cables.
CABLES
MOTOR MOUNTING
BOLTS
6 x 1.0 mm 8 N-m
(0.8 kg-m, 5.8 Ib-ft)
Loosen.
MOUNTING BOLTS
6 x 1.0 mm
8 N-m (0.8 kg-m,
5.8 Ib-ft)
CORROSION RESISTANT BOLT
22. Remove the mounting bolts, then remove the inside
stabilizers from the door.
NOTE: Scribe a line around the mounting bolts to
show the original adjustment.
INSIDE STABILIZERS
CORROSION RESISTANT BOLT
then take out the
regulator
MOUNTING
BOLT
MOUNTING BOLT
8 x 1.25 mm
22 N-m (2.2 kg-m, 16 Ib-ft)
MOUNTING
BOLT