Acura NSX 1991 Manual page 75

Main Menu
Engine Removal/Installation
Removal
32. Remove the left and right parking brake cables (see
section 19).
33. Remove the rear beam rod assembly and parking
brake cable clamps. '
REAR BEAM
ROD ASSEMBLY
10 x 1.25 mm
60 N-m (6.0 kg-m,
43 Ib-ft)
34. Remove the front engine mount, then remove the
front beam.
12 x 1.25 mm
77 N-m (7.7 kg-m, 56 Ib-ft)
Replace.
12 x 1.25 mm-
95 N-m (9.5 kg-m,
69 Ib-ft)
CORROSION RESISTANT BOLT/NUT
Table of Contents
12 x 1.25 mm
95 N-m (9.5 kg-m,
69 Ib-ft)
35. Remove the A/C compressor (see
suspend it from the body.
NOTE:
• Do not remove the compressor hoses.
• Do not let the compressor hang by its hoses.
36. Reinstall the front beam and front engine mount.
A/C COMPRESSOR
37. Remove the rear brake hoses, then plug the brake
pipes with rubber caps (see
38. Disconnect the left rear wheel sensor connector,
then remove the wheel sensor wire clamps and sta-
bilizer link.
6 x 1.0 mm
10 N-m (1.0 kg-m,
7 Ib-ft)
STABILIZER
LINK
section 22), then
Hang with wire
or rope.
section 19).
LEFT REAR
WHEEL SENSOR
CONNECTOR
SELF-LOCKING NUT
12 x 1.25 mm
95 N-m (9.5 kg-m,
69 Ib-ft)
Replace.
SELF-LOCKING NUT
12 x 1.25 mm
85 N-m (8.5 kg-m, 62 Ib-ft)
Replace.