Acura NSX 1991 Manual page 390

Main Menu
Driveshafts
Disassembly
1. To remove the boot band, pry up the locking tabs
with screwdriver, and raise the end of the band.
NOTE: Carefully clamp the driveshaft in a vise
with soft jaws.
CAUTION: Take care not to damage the boots.
LOCKING TABS
2. Remove both joints.
• Outboard joint side only:
— Remove the circlip from the outboard joint
groove.
— Remove the outboard joint and spring.
CIRCLIP
SPRING
CAP
Table of Contents
Outboard joint only.
3. Remove the rollers from the spider.
4. Remove the set ring; then remove the spider with a
bearing remover.
NOTE: Before disassembly, mark the spider and
driveshaft so they can be reinstalled in their original
positions.
SET RING
Mark
SPIDER
Mark
SET RING
ROLLER
BEARING REMOVER
SPIDER
DRIVESHAFT