Table of Contents
Advertisement
Main Menu
Replacement
1.
Disconnect the negative cable from the battery.
2.
Remove the from bumper (see
3. Recover the refrigerant using a R-134a refrigerant
Recover/Recycling/Charging System (see page
22-73).
4.
Disconnect the discharge line C and the condenser
lines from the condenser. Cap the open fittings
immediately to keep moisture and dirt out of the
system.
(Right Condenser)
(Left Condenser)
CONDENSER
LINE C
CONDENSER
LINE A
Table of Contents
section
20).
CONDENSER
LINE A
DISCHARGE
LINE C
5.
Disconnect the connector from the condenser fan,
remove the two mounting bolts and nut, then
remove the condenser.
*: CORROSION RESISTANT BOLT
(Right Condenser)
CONNECTOR
NUT
* MOUNTING BOLTS
6 x 1,0 mm
10 N·m ( 1 . 0
kg-m, 7 Ib-ft)
(Left Condenser)
LEFT CONDENSER
6.
Install the condenser in the reverse order of
removal; and:
If you're installing a new condenser, add
refrigerant oil (ND-OIL 8) (see page
Replace 0-rings with new ones at each fitting,
and apply refrigerant oil to them.
NOTE: Be sure to use the right O-rings for
R-134a to avoid leakage.
Charge the system (see page 22-91) and test its
performance (see page 22-70).
RIGHT CONDENSER
NUT
CONNECTOR
* MOUNTING BOLTS
6 x 1.0 mm
10 N·m (1.0 kg-m. 7 Ib-ft)
22-69
).
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
