Acura NSX 1991 Manual page 286

Main Menu
Slave Cylinder
Removal
1. Disconnect the clutch hose from the slave cylinder.
CAUTION:
• Avoid spilling brake fluid on the painted sur-
faces, as it may damage the finish.
• Plug the end of the clutch hose with a shop
towel to prevent brake fluid from coming out.
2. Remove the slave cylinder from the clutch housing.
BOOT
Remove and check for signs of leaking
and deterioration.
Table of Contents
SLAVE
CYLINDER
CLUTCH
HOSE
O-RING
Replace.
Installation
Super High
08798-9002).
Brake Assembly Lube or equivalent rubber
grease.
1. Install the slave cylinder on the clutch housing.
SLAVE CYLINDER
8 x 1.25 mm
22 N-m (2.2 kg-m,
16 Ib-ft)
(P/N 08798-9002)
(Brake Assembly
Lube)
2. Bleed the clutch hydraulic system:
• Attach a hose to the bleeder screw, then suspend
the hose in a container of brake fluid.
• Make sure there is an adequate supply of fluid at
the master cylinder, then slowly pump the
clutch pedal until no more bubbles appear at the
bleeder hose.
• Refill the master cylinder fluid when done.
• Use only DOT 3 or 4 brake fluid.
Temp Urea Grease (P/N
10 N-m (1.0 kg-m,
7 Ib-ft)
6 x 1.0 mm
10 N-m (1.0 kg-m,
7 Ib-ft)