Acura NSX 1991 Manual page 668

Main Menu
Seals/Retainers Alignment
Adjustment
NOTE: When the following parts have been replaced or
removed, this adjustment should be done.
• Roof side seals
• Roof side lock units
• Front and rear pillar seals
CAUTION: To prevent damage, place the roof on an
appropriate pad.
1. Remove the roof front trim and roof side trim (see
page 20-82).
2. Install the roof side lock handle.
3. Turn the roof side lock handle to the locked posi-
tion.
4. Loosen the roof side lock unit mounting nuts, then
tighten them lightly.
ROOF SIDE
LOCK UNIT
5. Return the roof side lock handle to the unlocked posi-
tion.
Table of Contents
ROOF SIDE
LOCK HANDLE
NUTS
6 x 1.0 mm
11 N-m (1.1 kg-m,
8 Ib-ft)
Loosen.
NUTS
6 x 1.0 mm
11 N-m (1.1 kg-m,
8 Ib-ft)
Loosen.
6. Remove the front and rear roof rail trim (see page
20-79).
7. Loosen the lock receiver mounting bolts at each of the
four corners, then tighten them lightly.
Front:
FRONT LOCK
RECEIVER
Rear:
BOLTS
8 x 1.25 mm
22 N-m (2.2 kg-m,
16 Ib-ft)
Loosen.
8. Install the roof on the body.
CAUTION: When installing the roof, make sure both
roof side locks are unlocked.
NOTE: Make sure each roof side hook aligns with the
hook stop properly.
BOLTS
8 x 1.25 mm
22 N-m (2.2 kg-m,
16 Ib-ft)
Loosen.
REAR LOCK
RECEIVER