Acura NSX 1991 Manual page 815

Main Menu
A/T Gear Position Indicator
A/T Gear Position Switch Test
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS section 24
vice.
1. Remove the console, then disconnect the 12-P and
2-P connectors from the A/T gear position switch.
2. Check for continuity between the terminals in each
switch position according to the table.
• Move the lever back and forth at each switch
position without touching the push button, and
check for continuity within the range of free play.
• If there is no continuity within the range of free
play, adjust the position of the switch as described
below.
A/T Gear Position Switch
Adjustment:
1. Shift to position, and loosen the bolts.
2. Slide the switch in the direction of
in 2.0 mm (0.08 in)] until there is continuity between
No. 8 and No. 11 terminals in the range of free play
of the shift lever.
3. Recheck for continuity between each of the termi-
nals.
NOTE:
• If adjustment is not possible, check for damage
to the shift lever detent and/or bracket. If there is
no damage, replace the A/T gear position switch.
• You should be able to start the engine with the
shift lever in position
play.
Table of Contents
before performing repairs or ser-
position [with-
within the range of free
View from wire side
Position P
BOLTS
A/T GEAR POSITION SWITCH
Back-up Neutral
Light Switch Position Switch
LOCK PIN