Acura NSX 1991 Manual page 76

Main Menu
39. Remove the right wheel sensor wire clamps and
stabilizer link.
SELF-LOCKING NUT
12 x 1.25 mm
95 N-m (9.5 kg-m,
69 Ib-ft)
Replace.
40. Disconnect the front secondary heated oxygen sensor
connector, then remove the front exhaust pipe A and
front three way catalytic converter (TWC).
41. Separate the rear TWC from the rear joint pipe.
SELF-LOCKING NUTS
10 x 1.25 mm
34 N-m (3.4 kg-m, 25 Ib-ft)
Replace.
GASKET
Replace.
SELF-LOCKING NUT •
10 x 1.25 mm
55 N-m (5.5 kg-m, 40 Ib-ft)
Replace.
Table of Contents
6 x 1.0 mm
10 N-m (1.0 kg-m,
7 Ib-ft)
STABILIZER
LINK
SELF-LOCKING NUT
12 x 1.25 mm
85 N-m (8.5 kg-m, 62 Ib-ft)
Replace.
GASKETS
Replace.
42. Position the special tool under the car. Lower the car
just above the fixture. With the help of an assistant,
attach the fixture to the subframe with two 12 mm
nuts and two 10 mm bolts.
LOOSELY INSTALL TWO 12 mm
NUTS ON STUDS HERE
LOOSELY INSTALL ONE
10 mm BOLT HERE
43. Adjust the pads on the fixture to support the oil pan
and transmission housing.
44. Lower the car so the fixture is resting on its casters
(or appropriate platform).
45. Remove the two bolts from the side engine mount
near the alternator. Pivot the mounting bracket into
the housing of the body.
SIDE ENGINE
MOUNT
ENGINE REMOVAL/
INSTALLATION
FIXTURE
07MAK-PR7020A
BODY SUPPORT
BRACKET