Acura NSX 1991 Manual page 573

Main Menu
NOTE:
Place the vehicle on a firm, level surface when ad-
justing the glass.
Make sure the door position is adjusted properly
before adjusting the glass(see page
18('91-'92)
Lower the glass fully.
1. Remove:
Door panel/Plastic cover (see pages 20-7('93-'96),
6('91-'92),8('93-'96),7('91-'92)
Door trim (see page
Upper weatherstrip (see page
20('91-'92)
Front and center pillar retainers (see page
20('91-'92)
NOTE: Check the weatherstrip for damage and de-
terioration, and replace it if necessary,
2. Remove the switch panel from the door panel (see
page 20-8('93-'96),7('91-'92).
3. Connect the switch panel connector to the wire
harness.
NOTE: Take care not to scratch the switch panel.
WIRE HARNESS
4. Carefully close the door while holding the door
glass to prevent it from contacting the body panel.
5. Raise the glass fully.
NOTE: Check the door fit to the body opening,
6. Measure and record the clearance "H" and "B"
between the glass and body at the locations
shown.
7. Adjust the clearance as described in the steps 8
thru 9.
Table of Contents
20-19 ('93-'96),
20-38('93-'96),37('91-'92)
20-21('93-'96)
20-21 ('93-'96)
SWITCH
PANEL
Measuring Points:
Section:
WINDSHIELD
PLASTIC
GROMMET
Section:
Section:
"H" Clearance
GLASS
"B" Clearance
Standard Clearance:
Permissible tolerance: ±2 mm (0.08 in)
"H" Clearance
GLASS
"B" Clearance
"H" Clearance
GLASS
"B" Clearance
Unit: mm (in)
(cont'd)