Acura NSX 1991 Manual page 626

Main Menu
Trunk Lid Opener/Latch:
NOTE: Take care not to bend the cable and rod.
TRUNK LID OPENER
CABLE
LATCH MOUNTING
BOLTS
6 x 1.0 mm
10 N-m (1.0 kg-m,
7.2 Ib-ft)
REAR PANEL MOUNTING
NUTS
TRUNK LID
OPENER CABLE
LOCK ROD
OPENER CABLE
Table of Contents
TRUNK LID OPENER
CABLE Replacement,
see page 20-67
LOCK CYLINDER
MOUNTING BOLT
6 x 1.0 mm
10 N-m (1.0 kg-m,
7.2 Ib-ft)
TRUNK LID LATCH
Remove the latch mounting
bolts and disconnect the lock
rod, opener cable, connector
TRUNK LID
and clip, then remove the trunk
LATCH
lid latch from the hole in the
body panel.
TRUNK LID OPENER
MOUNTING BOLTS
ACTUATOR
6 x 1.0 mm
10 N-m (1.0 kg-m, 7.2 Ib-ft)
CONNECTORS
Installation is the reverse of the removal procedure.
NOTE: Make sure the opener cable is routed and
connected properly.
TRUNK KEY SWITCH
Be careful not to damage the
trunk key switch.
LOCK CYLINDER
Disconnect the connector and
lock rod from the trunk lid latch.
Remove the rear panel and turn
the lock cylinder 45°.
Remove the lock cylinder from
the hole in the body panel.
LOCK CYLINDER
HARNESS
CLIP
REAR PANEL
BOLT
REAR PANEL
CORROSION RESISTANT BOLT/NUT
LOCK
ROD