Table of Contents
Advertisement
Main Menu
Synchro Sleeve, Synchro Hub
Inspection
1.
Inspect gear teeth on all synchro hubs and synchro
sleeves for rounded off corners, which indicates
wear.
2.
Install each synchro hub in its mating synchro
sleeve, and check for freedom of movement.
NOTE: If replacement is required, always replace
the synchro sleeve and synchro hub as a set.
SLEEVE
Table of Contents
Installation
Each synchro sleeve has three sets of longer teeth (120
degrees apart) that must be matched with the three
sets of deeper grooves in the synchro hub when
assembled.
HUB
NOTE: Installing the synchro sleeve with its longer
teeth in the synchro hub slots will damage the spring
ring.
LONGER TEETH
SYNCHRO
HUB
SYNCHRO
SLEEVE
SYNCHRO
HUB SLOT
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
