Main Menu
Table of Contents
Camshafts
Installation
CAUTION: Valve locknuts should be loosened and ad-
justing screws backed off before installation.
1.
After wiping down the camshaft and journals in the
cylinder head, lubricate both surfaces and install the
camshafts and rubber caps.
NOTE: Apply liquid gasket around the rubber cap.
2.
Turn the camshaft until its keyway is facing up. (No. 1
cylinder TDC).
3.
Set a new O-ring and a dowel pin in the oil passage
of the No. 1 camshaft holder.
4.
Install the camshaft seals with the open side
(spring) facing in.