Main Menu
Reassembly
CAUTION:
• Prior to reassembling, clean all the parts in solvent,
dry them, and apply lubricant to any contact parts.
• Press the 3rd, 4th and 5th gears on the countershaft
without lubrication.
• When installing the 3rd, 4th and 5th gears, support
the shaft on steel blocks, and install the gears using
a press.
• Install the 3rd, 4th and 5th gears with a maximum
pressure of 1,000 kg, then press all three gears with
a pressure of 2,600 kg.
NOTE: To reassemble, see page 13-29.
1.
Support the countershaft on a steel block as shown,
and install 3rd gear using a press.
2.
Install 4th gear using a press as shown.
Table of Contents
PRESS
3RD GEAR
PRESS
4TH GEAR
3.
Install 5th gear using a press as shown.
4.
Install the needle bearing using a press as shown,
then install the bearing outer race.
PRESS
5TH GEAR
PRESS
NEEDLE BEARING