Table of Contents
Advertisement
Main Menu
Taillights
Replacement
1.
Open the trunk lid, and remove the rear trim panel.
2.
Disconnect the 8-P connector and 2-P connector
from the taillight assembly.
3.
Disconnect the 2-P connector from the trunk key
cylinder switch.
8-P CONNECTOR
TRUNK KEY CYLINDER
CONNECTOR
4.
Remove the four mounting nuts and rear panel, then
remove the ten mounting nuts and the taillight as-
sembly.
NEW GASKET
REAR PANEL
TAILLIGHT ASSEMBLY
5.
Inspect the gasket; if it is distorted or stays com-
pressed, replace it.
6.
After installing, run water over the lights to make
sure they don't leak.
Table of Contents
2-P CONNECTOR
REAR TRIM PANEL
Bulb Replacement
1.
Open the trunk lid, and remove the rear trim panel.
2.
Turn each socket 45° counterclockwise to remove
them from the taillight housing.
SOCKET
TURN SIGNAL LIGHT BULB (45CP)
and
BRAKE LIGHT/TAILLIGHT BULBS (32CP/2CP)
TAILLIGHT BULB (2CP)
BACK-UP LIGHT BULB (32CP)
3.
Remove the bulbs from the sockets.
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
