Acura NSX 1991 Manual page 541

Main Menu
Bleeding
Air Bleeding with ALB Checker
1. Disconnect the 6-P inspection connector (PNK)
from the connector cover located under the glove
box, and connect the 6-P inspection connector to
the special tool.
ALB CHECKER
07HAJ - SG0010B
CAUTION: Place the vehicle on level ground with
the wheels blocked. Put the transmission in neutral
for manual transmission models, or in
matic transmission models.
2. Fill the modulator reservoir to the MAX level line.
NOTE: Do not reuse aerated brake fluid that has
been bled from the power unit.
3. Bleed high-pressure fluid from the maintenance
bleeder with the special tool.
SOLENOID UNIT
ACCUMULATOR/
PRESSURE SWITCH
Table of Contents
CONNECTOR
COVER
6-P INSPECTION
CONNECTOR
for auto-
BLEEDER T-WRENCH
07HAA-SG00100
or
07HAA-SG00101
MAINTENANCE
BLEEDER
8 x 1.25 mm
9 N-m (0.9 kg-m,
POWER
6.5 Ib-ft)
UNIT
4. Start the engine and release the parking brake.
NOTE: Depress the brake pedal firmly while test in
progress light in ON.
5. There should be at least two strong kickbacks.
If not, repeat steps 2 through 5, as necessary.
6. Fill the modulator reservoir up to the MAX level
line.
MAX LEVEL LINE
7. Install the reservoir cap.
8. Check the anti-lock brake system function in all
modes by using the ALB checker.
RESERVOIR CAP