Acura NSX 1991 Manual page 867

Main Menu
Side Marker/Turn Signal/Hazard Flasher System
Hazard Warning Switch Replacement
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS section 24 before performing repairs or ser-
vice.
1. Remove the dashboard lower cover, and disconnect
the connectors.
2. Remove the dashboard lower pad.
DASHBOARD LOWER
COVER
3. Remove the tilt cover.
Table of Contents
DASHBOARD LOWER
PAD
TILT COVER
4. Remove the steering column covers.
NOTE: Be careful not to damage the steering column
covers.
UPPER COVER
LOWER COVER
5. Disconnect the 20-P, 4-P, and 5-P connectors.
CAUTION: Be careful not to damage the SRS wire
harness.
6. Remove the six screws, then remove the hazard
warning-wiper switch assembly.
20-P CONNECTOR
HAZARD
WARNING
SWITCH