Acura NSX 1991 Manual page 352

Main Menu
Transmission Assembly
Installation
NOTE:
• Check that the two dowel pins are installed in the clutch housing.
• Use only Super High Temp Urea Grease (P/N 08798-9002).
1. Place the transmission on the transmission jack, and raise it to the engine level.
2. Set the release fork to the clutch housing.
3. Install the two transmission housing mounting bolts and engine stiffener.
4. Install the three rear transmission mounting bolts.
5. Loosen the front engine mounting bolt, then install the two front engine
mounting bolts to the transmission side.
6. Remove the transmission jack.
7. Install the clutch housing cover.
DOWEL PINS
(P/N 08798-9002)
8. Install the release fork in the release hanger, then install the slave cylinder.
9. Connect the shift cable and select cable.
CAUTION: Take care not to bend the cables.
10. Install the upper cover, change wire bracket and lower cover.
11. Install the upper control arm mounting bolt.
Corrosion resistant bolt/nut
8 x 1.25 mm
22 N-m (2.2 kg-m,
16 Ib-ft)
UPPER COVER
COTTER PIN
Replace.
6 x 1.0 mm
12 N-m (1.2 kg-m,
9 Ib-ft)
CHANGE
WIRE
BRACKET
8 x 1.25 mm
26 N-m (2.6 kg-m, 19 Ib-ft) 12 N-m (1.2 kg-m, 9 Ib-ft)
Table of Contents
Corrosion resistant bolt/nut
REAR TRANSMISSION
TRANSMISSION
MOUNTING BOLTS
JACK
12 x 1.25 mm
105 N-m
(10.5 kg-m, 76 Ib-ft)
SLAVE CYLINDER
6 x 1.0 mm
10 x 1.25 mm
45 N-m (4.5 kg-m, 33 Ib-ft)
TRANSMISSION HOUSING MOUNTING BOLT
12 x 1.25 mm
65 N-m (6.5 kg-m, 47 Ib-ft)
LOWER
COVER
UPPER CONTROL ARM MOUNTING BOLT
10 x 1.25 mm
60 N-m (6.0 kg-m, 43 Ib-ft)
(P/N 08798-9002)
TRANSMISSION HOUSING
MOUNTING BOLTS
12 x 1.25 mm
65 N-m (6.5 kg-m, 47 Ib-ft)
FRONT ENGINE
MOUNTING BOLT
10 x 1.25 mm
60 N-m (6.0 kg-m, 43 Ib-ft)
8 x 1.25 mm
22 N-m (2.2 kg-m, 16 Ib-ft)
6 x 1.0 mm
12 N-m (1.2 kg-m,
9 Ib-ft)
CLUTCH HOUSING
COVER