Acura NSX 1991 Manual page 146

Main Menu
OIL PUMP SIDE:
6 x 1.0 mm
12 N-m (1.2 kg-m, 9 Ib-ft)
BAFFLE PLATE
OIL PASS
PIPE
OIL PUMP
SPECIAL BOLTS
Apply liquid
6 x 1.0 mm
gasket to block
12 N-m (1.2 kg-m,
mating surfaces.
9 Ib-ft)
Replace.
NOTE:
• Use liquid gasket, Part No. 08718-0001.
• Check that the mating surfaces are clean and
dry before applying liquid gasket.
• Apply liquid gasket evenly, being careful to cover
all of the mating surface.
• To prevent leakage of oil, apply liquid gasket to
the inner threads of the bolt holes.
Table of Contents
OIL SCREEN
6 x 1.0 mm
12 N-m (1.2 kg-m,
9 Ib-ft)
SPECIAL BOLTS
8 x 1.25 mm
22 N-m (2.2 kg-m,
16 Ib-ft)
Replace.
Apply liquid gasket
along the broken line.
OIL PUMP
Apply liquid gasket
along the broken line.
• Do not install the parts if five minutes or more
have elapsed since applying liquid gasket.
Instead reapply liquid gasket after removing old
residue.
• After assembly, wait at least 20 minutes before
filling the engine with oil.
9. Install the oil pass pipe and joint.
10. Install the baffle plate.
11. Install the oil screen.
12. Install the oil pan (see page 8-10).
CAUTION: Whenever any crankshaft or connec-
ting rod bearing is replaced, after reassembly, run
the engine at idling speed until it reaches normal
operating temperature, then continue to run for ap-
proximately 15 minutes.
LEFT
SIDE COVER