Olivetti d-Copia 6500MF Plus Service Manual page 88

4. Insert the gigabit ethernet board along
the groove in OPT2 and secure the
board with two pins that have been
removed in step 3.
*: Do not directly touch the gigabit ethernet
board terminal.
Hold the top and bottom of the gigabit
ethernet board, or the projection of the
board to insert the gigabit ethernet board.
5. Plug the network cable into the
connector.
6. Refit the controller cover.
*: Load the CD-ROM in the PC and run
"Quick Network Setup" to set the IP
address.
Service Manual
1
P T
Groove
Figure 1-2-8 7
1
P T
Figure 1-2-8 8
1-2-5 6
2N8/2N7
Gigabit
ethernet board
Pin
Pin
Y116520-