Olivetti d-Copia 6500MF Plus Service Manual page 279

Item No.
U411 Method: [DP FaceUp (Chart2)]
1. Set a specified original (P/N: AVGR11211F) on the DP.
Cut the trailing edge of the original.
2. Enter maintenance item U411.
3. Select [Target].
4. Select [U425] and press the start key.
5. Select [DP FaceUp (Chart2)].
6. Select [INPUT].
Input
7. Press the start key. Auto adjustment starts.
* : When automatic adjustment has normally completed, [OK] is displayed. If a problem
occurs during auto adjustment, error code is displayed and operation stops. Should this
happen, determine the details of the problem and repeat the procedure from the begin-
ning ( P.1-3-159).
Method: [DP FaceDown (Chart2)]
1. Place the specified original for acquiring gamma target data (P/N: AVGR05133T) on the
platen, and press the start key.
2. Place the specified original for acquiring matrix target data (P/N: AVGR05134Q) on the platen,
and press the start key.
When normally completed, [OK] is displayed.
3. Select the item.
Y116520-3
Display
Executing the adjustment in the DP scanning section (first
side) for magnification, leading edge timing and center line
Description
74 ± 1 mm
Figure 1-3-45
Description
1-3-157
2N8/2N7-3
5 mm
149 ± 1 mm
Service Manual