Olivetti d-Copia 6500MF Plus Service Manual page 57

Unlocking the developer waste exit
Caution
To ease setup, the device was shipped
with the developer unit already replenished
with developer. Therefore, to prevent
developer from spilling during shipping, a
developer shutter is equipped with the
developer unit.
To disengage the shutter, use the following
procedure: Note that if the shutter is not
completely disengaged and retained in
place, the developer in the developer unit
may clog at the outlet causing a damage to
the developer unit.
1. Remove two tapes and then remove the
set up leaflet.
*: The setup leaflet must be affixed in posi-
tion before dispatching the machine.
2. Open the waste toner box cover.
3. Pull the paper conveying unit out.
4. Remove the two screws and then open
the front middle cover.
Y116520-3
Tape
Wate toner
box cover
Set up leaflet
1-2-25
Tape
Figure 1-2-40
Front middle
cover
Screw
Figure 1-2-41
Service Manual
2N8/2N7
Screw