Olivetti d-Copia 6500MF Plus Service Manual page 278

Item No.
U411 Method: [Table (Chart2)]
1. Enter the target values which are shown on
the back of the Chart 2-1original
(P/N: AVGR05131K) executing maintenance
item U425.
2. Set a Chart 2-1original on the platen.
3. Enter maintenance item U411.
4. Select [Target].
5. Select [U425] and press the start key.
6. Select [Table (Chart2)].
7. Select the item.
All
Input
C.A.
MTF
Gamma
Matrix
8. Press the start key. Auto adjustment starts.
* : When automatic adjustment has normally completed, [OK] is displayed. If a problem
occurs during auto adjustment, error code is displayed and operation stops. Should this
happen, determine the details of the problem and repeat the procedure from the begin-
ning ( P.1-3-159).
Service Manual
Display
Executing the all scanner adjustment
Executing the adjustment for magnification, leading edge tim-
ing and center line
Executing the adjustment for chromatic aberration filter
Executing the adjustment for MTF filter
Executing the adjustment for input gamma
Executing the adjustment for matrix
Description
Description
1-3-156
2N8/2N7-3
Chart2-1
Figure 1-3-44
Y116520-