Olivetti d-Copia 6500MF Plus Service Manual page 359

Jam types
No-paper-feed jam or
the leading edge of
paper is curled back at
the position of the
roller
(J0501,J0502,
J0503,J0504, J0505,
J0506, J0507J0509,
J0523, J0524, J0525,
J0526, J0527, J0545)
Multiple-feed Jam
(J0511, J0512, J0513,
J0514, J0516, J0517,
J0519)
Y116520-3
Check description
7. Check the separation
roller is not disturbed as
a driving component is
in contact with the
frame during the
separation roller is in
motion.
8. Depress the release
lever to release the
pressure of the primary
feed rollers to check
that the retard holder
falls. (The pressure by
the retard roller to the
feed roller is
decreased.)
1. Check if the cutting
edge of the paper
bundle is crumpled or
the cassette is loaded
with multiple times of
replenishing paper.
2. Checking paper size.
Check that the size of
the loaded paper and
the paper size chosen
on the operator panel
are met.
3. Check if paper dusts
and abrasion are
observed on the paper
fanning roller and retard
roller.
Corrective measures
If it gets in contact, replace the primary feed unit.
Modify mounting the retard holder fixing plate.
If the cutting edge of the paper bundle is crumpled or
the cassette is loaded with multiple times of
replenishing paper, load new paper.
If the paper size does not agree.
1. If the cassette cursors are open against the
paper, set it properly.
2. Insert the cassette until the paper size detector
switch is turned on.
If the size is not detectable while automatic sizing
is enabled, replace the size detection switch.
If the paper size agrees
1. If paper other than complying the requirements
such as coated paper, inkjet paper, etc., is used,
replace the paper.
2. RE-assemble the pulley retard in the primary
feed unit if it is mounted to the oppisite direction.
3. Check if the spring retard has not been fallen off
of the mounting position. If the spring retard is
not dropped off of the mount position, decrease
the spring pressure that is applied to the
separation rollers.
4. Replace the primary feed unit.
If the paper fanning roller is dirty, clean.
If abrasion is observed, replace.
1-4-31
2N8/2N7
Service Manual