Olivetti d-Copia 6500MF Plus Service Manual page 717

6. Remove two connectors from the hard
disk unit while pushing the lock lever.
7. Remove four pins and then remove the
hard disk unit from the HDD bracket.
8. Replace the hard disk unit and refit all
the removed parts.
*: Handle the HDD so as not to drop or
get it in touch with hard objects as it is
susceptible to vibrations and impacts
especially along the direction of disc
rotation. Be careful not to apply shocks
while securing the screws.
9. Perform maintenance mode U024
(HDD formatting) -Format - Full
(see page 1-3-29).
10. Install the firmwares by the following procedure.
1)Connects to the machine the USB memory that preserved Software LANGUAGE BR (Opt Font, Opt
Msg, opt Eweb) and option language.
The firmware is installed by switching the main power switch to ON/OFF.
Install the OCR dictionary software in the same manner.
2)Connects to the machine the USB memory that preserved FMU application. Installs the firmware from
the application screen of the system menu (Refer to operation guide).
*: Confirm a kind of Hypas application displayed with an application screen before HDD exchange, and
install it again.
3)Reinstall the OCR dictionary software from a USB flash device by toggling power on and off.
11. If backup data is saved with the U917 maintenance mode, execute import of the backup data with the
U917 (see page 1-3-193).
Y116520-3
Lever
Connector
Figure 1-5-224
Pin
Pin
Figure 1-5-225
1-5-137
Hard disk unit
Black
Lever
Connector
HDD bracket
Hard disk unit
Service Manual
2N8/2N7-4
Pins