Olivetti d-Copia 6500MF Plus Service Manual page 352

Code Contents
7400 CF side registration sensor 2
non arrival jam
7500 CF side registration sensor 1
non arrival jam
7600 CF staple operation error
7700 CF paper conveying sensor
non arrival jam
7710 CF paper conveying sensor
stay jam
7800 MB eject sensor non arrival
jam
7810 MB eject sensor stay jam
7900 Middle paddle error jam
7950 Paper interval error jam
9000 No original feed jam
9001 DP original conveying jam
9002 DP sensor stay jam
9005 No original feed jam 2
9008 No original feed jam 3
9009 DP original conveying jam 2
9010 Document processor open
9011 DP top cover open
9110 DP feed sensor stay jam
*: Refer to figure 1-4-1 for paper misfeed indication (see page 1-4-1).
Service Manual
Conditions
CF side registration sensor 2 (CFSRS2) is not turned
on within specified time after driving the CF side regis-
tration motor 2 (CFSRM2).
CF side registration sensor 1 (CFSRS1) is not turned
on within specified time after driving the CF side regis-
tration motor 1 (CFSRM1).
CF staple sensor (CFSTS) is not turned on within
specified time after driving the CF staple motor
(CFSTM).
CF paper conveying sensor (CFPCS) is not turned on
even if a specified time has elapsed after the machine
eject signal was received.
CF paper conveying sensor (CFPCS) is not turned off
within specified time of its turning on.
MB eject sensor (MBES) is not turned on even if a
specified time has elapsed after the machine eject sig-
nal was received.
MB eject sensor (MBES) is not turned off within speci-
fied time of its turning on.
DF paddle sensor (DFPDS) is not turned on within
specified time after driving the DF middle motor
(DFMM).
An illegal inter-page or inter-copy interval has
occurred.
DP feed sensor (DPFS) does not turn on within speci-
fied time during the first sheet feeding (Retry 5 times).
DP timing sensor (DPTS) turn off within the specified
time since the sensor turn on.
Sensor in the conveying system is on since original
feeding starts.
DP lift sensor 1 (DPLS1) does not turn on within spec-
ified time of the lift plate rising.
DP CIS sensor (DPCS) does not turn on within speci-
fied time of the paper feed starting.
Next feed original became the stand-by states of
paper feed while reading the image.
Document processor is opened during original feed-
ing.
The DP top cover is opened during original feeding.
DP feed sensor (DPFS) does not turn off within speci-
fied time of DP timing sensor (DPTS) turning on.
1-4-24
2N8/2N7-1
Jam
location*
M
M
M
M
M
L
L
K
K
H
H
H
H
H
H
H
H
H
Y116520-