Olivetti d-Copia 6500MF Plus Service Manual page 208

Item No.
U140 2. Select [Execute].
3. Press the start key.
Setting: [Magnification]
1. Select the item to be set.
2. Change the setting value using the +/- keys or numeric keys.
Display
K
3. Press the start key. The value is set.
Method: [High Altitude]
1. Select Mode1 or Mode2
l
Mode1
Mode2
Initial setting: Mode1
2. Press the start key. The value is set.
3. Turn the main power switch off and on. Allow more than 5 seconds between Off and On.
Method: [Image Preference]
1. Select the Copy.
2. Change the value using the +/- or numeric keys.
Display
Copy
* : 1: Low 0: Normal +1: Deep
Setting: [Lead Density]
Purpose
Activates settings for the user who frequently uses a document with a solid black printing at the
leading edge (Such a document tends to entwine around the fuser roller).
1. Select the item to be set.
On
Off
* : Initial setting: Off
2. Press the start key. The setting is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Service Manual
Set it at the time of Black developing leak outbreak
Display
Execute AC calibration by normal bias control
If print density is low in an installation at high altitude, execute
calibration by fixing the bias potential.
Setting toner density at copying
Display
mode is performed
mode is not performed
Description
Description
Description
Description
Description
1-3-86
2N8/2N7-4
Setting Initial
range setting
12
-10 to1 5
Setting Initial
range setting
-1 to +1 0
Y116520-