Olivetti d-Copia 6500MF Plus Service Manual page 215

Item No.
U161 Setting: [Print]
1. Select the item to be set.
2. Change the setting value using the +/- keys.
Display
Full Speed
Print(Center)
Duplex Shift
(Center)
3. Press the start key. The value is set.
Setting: [Low Power Mode]
1. Select the item to be set.
Mode0
Mode1
Mode2
Initial setting: Mode0
2. Press the start key. The setting is set.
Setting: [Belt Mode]
1. Select the item to be set.
On
Off
* : Initial setting: Off
* : On: The fuser motor should be deactivated after 15 minutes in Ready state so that the
fuser belt refrains from revolving.
2. Press the start key. The setting is set.
Setting: [Ready Time Adjust]
1. Change the setting value using the +/- or numeric keys.
Display
Value
2. Press the start key. The setting is set.
* : Reducing the alpha value lowers the temperature at which aging is activated following the
quiet mode has been stable.
* : Lowering the alpha value could deteriorate the fuser performance due to aging would not
be activated during quiet mode.
Y116520-3
Description
Temperature at maximum
print speed (Center)
Temperature at duplex
printing (Center)
Display
Present state control mode (Usually not used)
Fuser control temperature reduction mode (For normal users)
Large volume output mode (For users who repeatedly print
approximately 1500 sheets at a time)
Display
Belt mode is performed
Belt mode is not performed
Compensating Values for the Activating Tem-
perature for Low-temperature Aging: (α)
Description
Setting
range
165
130 to 200
(°C)
0
-20 to 20
(°C)
Description
Description
Description
1-3-93
2N8/2N7-3
Initial setting
65ppm 80ppm
170
0
Setting
range setting
0 to 2 2
Service Manual
Initial