Olivetti d-Copia 6500MF Plus Service Manual page 165

Item No.
U051 5. Change the setting value using the +/- keys or numeric keys.
For output example 1, increase the value. For output example 2, decrease the value.
The greater the value, the larger the deflection; the smaller the value, the smaller the deflec-
tion.
6. Press the start key. The value is set.
Completion
Press the stop key. The indication for selecting a maintenance item No. appears.
U052 Setting the fuser motor control
Description
Enters the sensor data values described on the supplied sheet provided when the loop sensor is
replaced and Perform correction processing for the fuser motor.
Purpose
To perform when replacing the loop sensor or paper conveying unit.
Method
1. Press the start key.
2. Select the item.
Set Loop Sensor
Loop Sensor Control
Set Loop Sensor Valid
Chk Loop Sensor
Method: [Set Loop Sensor]
1. Select [Scanning Board1].
2. Enter the sensor data of DATA1 on the sheet supplied with
the loop sensor by using the [+] and [–] keys.
3. Select [Scanning Board2].
4. Enter the sensor data of DATA2 on the sheet supplied with
the loop sensor by using the [+] and [–] keys.
5. Press the start key. The value is set.
* : When replacing the conveying unit, enter the data speci-
fied on the maintenance report.
Y116520-3
Original
Display
Enter the data value for loop sensor
Set the loop sensor detection control
Sets the presence or absence of the loop sensor
Display the data value for loop sensor
Description
Copy
example 1 example 2
Figure 1-3-6
Description
1-3-43
Copy
How to read the sensor data value
(e.g.) 1
2
3
4
5
6
7
8
9
0
3 6 4
Service Manual
2N8/2N7