Olivetti d-Copia 6500MF Plus Service Manual page 297

Item No.
U464 Setting the ID correction operation
Description
Turn ID correction (calibration) on or off. Also, this allows individual settings for calibration opera-
tion.
Purpose
Implements various settings of calibration when poor image quality is caused or to allow various
settings of calibration depending on the user preference.
To perform the calibration when replacing the maintenance kit.
Method
1. Press the start key.
2. Select the item to be set.
Permission
Time Interval
Mode
On/Sleep Out*
AP/NE*
Leaving Time*
Driving Time*
Timing*
Target Value
Calib
*: Enabled when Mode is set to Custom.
Setting: [Permission]
1. Select On or Off.
On
Off
* : Initial setting: On
2. Press the start key. The setting is set.
Y116520-3
Display
Setting to turn calibration on/off
Setting the interval time of calibration after printing
Setting the image adjustment execution mode
Setting execution parameters for calibration when powered up
or reverted from auto-sleep
Paper interval calibration ON/OFF setting at the time of cali-
bration/near end after toner feed
Setting the standard time for judging whether or not to carry
out calibration based on the sleep time when the machine
recovers from the sleep mode
Setting the standard time for judging whether or not to carry
out paper interval calibration based on the driving time during
printing
Setting the standard time for judging whether or not to carry
out calibration based on the continuous print driving time dur-
ing printing
Setting the sensor target values for toner thick layer calibration
and light amount calibration
Executing the calibration
Display
Turn calibration ON
Turn calibration OFF
Description
Description
Description
1-3-175
2N8/2N7
Service Manual