Olivetti d-Copia 6500MF Plus Service Manual page 463

Code Contents
8210 DF slide motor error
When initial operation, DF sta-
ple sensor does not turn on
within 3 s.
8230 DF staple motor error 1
Staple JAM (DF) has been
detected twice in a row. (The
second JAM detection
condition fullfilled with the
home position did not
detected in 600 ms after the
motor was driven.)
Y116520-3
Related parts
DF slide motor
DF staple sensor
DF main PWB Replace the DF main PWB (Refer to the
service manual for the document finisher).
DF staple motor
DF staple sensor Replace the staple unit.
DF main PWB Replace the DF main PWB (Refer to the
service manual for the document finisher).
1-4-135
Check procedures/
corrective measures
1. Execute U240 Motor - Staple Move to
check the finisher operation (see page
1-3-116).
2. Manipulate the staple unit back and forth
to check it is smoothly operable.
3. Check that the drive from the motor
reaches the staple unit.
4. Confirm that the wiring connector is
firmly connected and, if necessary,
connect the connector all the way in.
DF slide motor and DF main PWB
(YC12)
5. If the wiring is disconnected, shorted or
grounded, replace the wiring.
6. Replace the DF slide motor.
1. Execute U241 Finisher - Width Staple
HP to check the finisher switch (see
page 1-3-118).
2. Check that the sensor and its mounting
bracket are correctly positioned.
3. Confirm that the wiring connector is
firmly connected and, if necessary,
connect the connector all the way in.
DF staple sensor and DF main PWB
(YC22)
4. If the wiring is disconnected, shorted or
grounded, replace the wiring.
5. Replace the DF staple sensor.
1. Remove the staple unit and check that
stapling is possible without a jam.
2. Confirm that the FFC wiring connector is
not distorted and connect the FFC wiring
all the way in.
Staple unit and DF main PWB (YC17)
3. If the wiring is disconnected, shorted or
grounded, replace the wiring.
4. Replace the staple unit. (Refer to the
service manual for the document
finisher).
2N8/2N7
Service Manual