Olivetti d-Copia 6500MF Plus Service Manual page 161

Item No.
U034 5. Change the setting value using the +/- keys or numeric keys.
For output example 1, increase the value. For output example 2, decrease the value.
6. Press the start key. The value is set.
Caution
Check the copy image after the adjustment. If the image is still incorrect, perform the following
adjustments in maintenance mode for optimizing reading positions.
U034
Setting: [Mode]
1. Select On or Off.
On
Off
2. Press the start key.
Setting: [Reset]
1. Select [Execute].
2. Press the start key.
Setting: [On Timing/ Off Timing]
1. Select the item.
Value (Plain)
Value (Thick)
2. Press the start key. The value is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Y116520-3
Center line of printing
(within ± 2.0 mm)
Correct image
U067
(P.1-3-54)
Table
Display
Sets the conveying timing verification mode on.
Sets the conveying timing verification mode off.
Display
Confirms the measured values of Plain.
Confirms the measured values of Thick.
Description
Output
example 1
Figure 1-3-5
U072
(P.1-3-60)
DP
Description
Description
1-3-39
Output
example 2
Service Manual
2N8/2N7