Olivetti d-Copia 6500MF Plus Service Manual page 360

Jam types
Multiple-feed Jam
(J0511, J0512, J0513,
J0514, J0516, J0517,
J0519)
Duplex No-original-
feed Jam (J0508)
Duplex Multiple-feed
Jam (J0518)
Intermediate/
conveying sensor stay
jam
(J1313, J1314, J1513,
J1514)
Service Manual
Check description
4. Select the motor by
U032 and check the
clutch rotates following
the other component
when the motor is
turned on. (see page 1-
3-34)
Perform U031 to check if
the duplex sensor 2 is
detected. (see page 1-3-33)
1. Check to see if the
actuator is operative
without hinderance.
2. Perform U031 to check
the operation of the
sensor.
3. Select the motor by
U032 and check if the
coveying clutch rotates
following the other
component. (see page
1-3-34)
4. Check if the conveying
guide is twisted to be
mounted.(If the
mounting parts of the
guide is floated, the
actuator won't protrude
sufficiently.)
5. Check no wrinkles are
observed at the sluck of
paper during paper
feeding.
Corrective measures
If the clutch rotates following the other component
and its stain is observed, replace the clutch.
If the duplex sensor 2 is not working, replace the
duplex sensor 2.
If it won't operate without hinderance, re-assemble or
replace the actuator's return spring.
If the sensor is inoperative, replace.
If stained, replace the clutch.Re-assmeble the clutch
so that it is not continuously energized. (Change of
wirings, etc.)
If the bracket is twisted to be mounted, remove the
screw fixing the conveying guide and properly mount
the bracket in the right position and fix again.
Adjust the cursors to the size of the paper.
(If paper is fed askew, perform a skew cancellation
adjustment of the width adjuster cursor.) (see page 1-
5-140)
1-4-32
2N8/2N7
Y116520-