Olivetti d-Copia 6500MF Plus Service Manual page 705

(5) Adjusting the angle of trailing edge
Perform the following adjustment if the trailing edge of the copy image is laterally skewed.
Procedure
1. Place an original on the DP and press
the start key to make a test copy.
2. If the gap of trailing edge exceeds the
reference value, perform the following
adjustment.
Reference value
For simplex copying: Within ±3.0 mm
For duplex copying: Within ±4.0 mm
3. Open the DP top cover.
4. Remove the right hinge cover.
5. Remove the screw and then remove the
left hinge cover
Y116520-3
Copy
Original
example 1
Figure 1-5-207
Right hinge cover
Figure 1-5-208
1-5-125
3mm/4mm 3mm/4mm
Copy
example 2
DP top cover
Left hinge cover
Service Manual
2N8/2N7
Screw