Olivetti d-Copia 6500MF Plus Service Manual page 875

4. Remove the two screws holding the
paper conveying plate.
5. Clean the back of the paper conveying
plate.
* : Use a dry, soft cloth for cleaning.
6. Check that the toner outlet, to which the
cooling duct is joined in the developer
unit, is not clogged with toner.
7. Remove toner accumulated in the duct
by a vacuum cleaner via the toner out-
let.
8. Refit all the removed parts.
3. Cleaning the duct at the back of the developer unit
* : 300K Maintenance. Not required when a developer unit is replaced.
Procedure
1. Remove the developer unit
(see page P.1-5-56).
2. Remove toner inside the cooling ducts
using a vacuum cleaner.
Y116520-3
Toner exhaust port
2-4-11
Toner exhaust port
Screw
Paper conveying plate
Screw
Figure 2-4-3
Developer unit rear side
Figure 2-4-4
Service Manual
2N8/2N7