Olivetti d-Copia 6500MF Plus Service Manual page 214

Item No.
U161 Setting the fuser control temperature
Description
Changes the fuser control temperature.
Purpose
Normally no change is necessary. However, can be used to prevent curling or creasing of paper,
or solve a fuser problem on thick paper.
Method
1. Press the start key.
2. Select the item to be set.
Warm Up
Print
Low Power Mode
Belt Mode
Ready Time Adjust
Setting: [Warm Up]
1. Select the item to be set.
2. Change the setting value using the +/- keys.
Display
Ready
(Center)
Ready
(Edge)
Ready
(Press)
Drive
(Center)
Wait
(Center)
Low Power
(Press)
Full Speed
Shift(Center)
Pressure
(Press)
3. Press the start key. The value is set.
Service Manual
Display
Control temperature except at printing
Control temperature during printing
Heating power reduction control
Settings against broken fusing belt control
Setting the Temperature to Activate Aging
Description
Control temperature at dis-
playing Ready (Center)
Control temperature at dis-
playing Ready (Edge)
Control temperature at dis-
playing Ready (Press)
Stable temperature during
driving (Center)
Stable temperature during
halt (Center)
Control temperature at low
power consumption
(Press)
Full speed shift tempera-
ture (Center)
Pressurizing beginning
temperature (Press)
Description
Description
Setting
range
130 to 200 165
(°C)
100 to 200 140
(°C)
0 to 200 30
(°C)
130 to 200 170
(°C)
130 to 200 165
(°C)
0 to 200 130
(°C)
0 to 200 50
(°C)
0 to 200 150
(°C)
1-3-92
Initial setting
65ppm 80ppm
165
140
30
175
170
130
50
155
Y116520-
2N8/2N7