11. Open the DP.
12. Remove the original mat.
13. Place original mat with its Velcro
upward over the contact glass.
*: Align original mat corner that has 90
degrees of angle with the inner left cor-
ner of the original instruction panel.
14. Close DP and attach original mat onto it
with Velcros.
15. Make a test copy again.
16. Repeat steps 1 to 13 above until the
gap of the trailing edge falls within the
reference values.
Y116520-3
Original mat
Velcros
Original mat
1-5-127
DP
Velcros
Figure 1-5-211
Service Manual
2N8/2N7