Olivetti d-Copia 6500MF Plus Service Manual page 285

Item No.
U415 Adjusting the print position automatically
Description
Automatically adjusts timings at the print engine.
Adjustment for leading edge timing, center line and margin.
Purpose
Used to make respective auto adjustments for the print engine.
* : Execute this mode when the Chart 2-2 (AVGR11211F) is not available.
Method
1. Load A3/ledger paper.
Load A4/Letter when the large capacity feeder is used.
2. Press the start key.
3. Select [Execute].
4. Press the start key. A test pattern is outputted
5. Set the output test pattern as the original.
6. Press the start key.
Automatically Perform adjustment from the top to bottom cassettes.
7. When normally completed, [OK] is displayed.
If a problem occurs during auto adjustment, error code is displayed.
Error Codes
Codes
SFFF
C101
C102
C103
C104
C105
C106
C107
C108
CFFF
Completion
Press the stop key.
* : The screen for selecting a maintenance item No. is displayed.
Y116520-3
S001 Black band is not detected (main scanning direction far end)
S002 Black band is not detected (main scanning direction near end)
S003 Black band is not detected (auxiliary scanning direction leading edge)
S004 Black band is not detected (auxiliary scanning direction trailing edge)
S005 Auxiliary scanning direction skew error (1.5 mm or more)
S006 Main scanning direction skew error (1.5 mm or more)
S007 Original error (detection of reverse original paper)
S008 Original error (page mismatch)
Scanner other error
Adjustment value error (main scanning direction magnification)
Adjustment value error (auxiliary scanning direction magnification)
Adjustment value error (leading edge timing)
Adjustment value error (center line)
Adjustment value error (B margin)
Adjustment value error (A margin)
Adjustment value error (C margin)
Adjustment value error (D margin)
Controller other error
Description
Description
1-3-163
2N8/2N7-4
Service Manual