Detaching the drum motor
1. Remove the rear upper cover (see page
1-5-3).
2. Remove the toner disposal box (see
page 1-5-134).
3. Remove the rear lower cover (see page
1-5-3).
4. Remove the connector.
5. Release the wire saddle.
6. Remove three screws.
7. Remove the drum drive unit.
8. Remove two screws.
9. Remove the drive mounting bracket.
Y116520-3
Wire saddle
Connector
Figure 1-5-164
Screws
Screws
Screw
Figure 1-5-165
Drum motor
Figure 1-5-166
1-5-103
Screw
Drum drive unit
Drive mounting bracket
Screws
Service Manual
2N8/2N7