Minimum Bending Radius For Hybrid Cable - Danfoss VLT ISD 510 Operating Manual

VLT® Servo Drive System ISD 510/DSD 510
Operating Guide
Pre-configured hybrid cables are used to connect the ISD 510/DSD 510 servo drives to the Decentral Access Module (DAM 510).
There are 2 types of hybrid cables that are available with both angled and straight M23 connectors:
• Feed-in cable for connecting the 1st ISD 510/DSD 510 servo drive of a group to the connection point on the Decentral Access
Module (DAM 510).
• Loop cable for connecting the ISD 510/DSD 510 servo drives in daisy-chain format in an application.
Both these cables are provided by Danfoss and are available in various lengths. See the VLT® Servo Drive System ISD 510, DSD 510,
MSD 510 (VLT® Flexmotion
™
Both ends of the loop cable are fitted with M23 connectors.
The feed-in cable is fitted with an M23 connector at the output end for connection to the 1st ISD 510/DSD 510 servo drive. At the
input end it is pigtailed and the connectors are mounted on the corresponding terminals on the Decentral Access Module (DAM
510).
Table 15: Hybrid Cables
Cable type Shielded/unshielded
Feed-in cable Shielded
Loop cable
-
Hybrid cables are available in 2 cross-sections: 2.5 mm
-
See the VLT® Servo Drive System ISD 510, DSD 510, MSD 510 (VLT® Flexmotion
1
VLT® ISD 510 Hybrid xxxx Cable
2
3
Ordering no. 175Gxxxx
4
Specification no. 175Rxxxx Rev. xxx
5
Production: dd.mm.yyyy
6
Length: xxxx
Power rating: 5 x 2.5mm 2 1000V 15A
7
Signal rating: 2 x 0.5mm 2
8
Signal rating Ethernet: 2 x 2 x AWG24 300V
9
1 7 5 G
Illustration 12: Example of a Hybrid Cable Nameplate
1 Cable type
2 Ordering code
3 Revision of specification
4 Manufacturing date
5 Length

3.9.1.1 Minimum Bending Radius for Hybrid Cable

The maximum number of bending cycles is 5 million at 7.5 x cable diameter (15.6 mm).
• Permanently flexible: 12 x cable diameter
• Permanently installed: 5 x cable diameter
Danfoss A/S © 2020.08
) Design Guide for further information.
Notes
Hybrid cable (overall shield with additional fieldbus and safety section shield).
N O T I C E
300V
8 9 X X
2 2
(15 A) and 4 mm (25 A for CE and UL, 20 A for CSA).
) Design Guide for further information.
™
10
6 Power rating
7 Signal rating
8 Signal rating for Ethernet
9 Barcode
10 Manufacturer logo
System Description
AQ262449648484en-000101 / 175R1135 | 41