Coupling The Isd 510 Servo Drive - Danfoss VLT ISD 510 Operating Manual

VLT® Servo Drive System ISD 510/DSD 510
Operating Guide
Illustration 25: Mounting of Size 1, 1.5 Nm, Size 2, 2.9 Nm, Size 2, 3.8 Nm, Size 3, and Size 4 ISD 510 Servo Drives
Illustration 26: Mounting of Size 2, 2.1 Nm ISD 510 Servo Drives

4.7.5.3 Coupling the ISD 510 Servo Drive

Observe the following safety warnings before coupling the ISD 510 servo drive.
-
Do not machine the shaft.
-
Do not use the ISD 510 servo drive if the shaft does not match the coupling arrangement.
Danfoss A/S © 2020.08
N O T I C E
Mechanical Installation
AQ262449648484en-000101 / 175R1135 | 55