Danfoss VLT ISD 510 Operating Manual page 142

VLT® Servo Drive System ISD 510/DSD 510
Operating Guide
Function Description
Guide value The guide value is used in all synchronous modes of operation (CAM mode and Gear mode). It is used as the
master position within the synchronous modes.
7.2 Operating Status Indicators
The operating status of the ISD 510/DSD 510 servo drive, PSM 510, DAM 510, and ACM 510 is indicated via the LEDs on each device.
7.2.1 Operating LEDs on the ISD 510/DSD 510 Servo Drive
DEV STAT
NET STAT
Illustration 104: Operating LEDs on the ISD 510/DSD 510 Servo Drive
Table 30: Operating LEDs on the ISD 510/DSD 510 Servo Drive
LED Color
DEV STAT Green
Red
NET STAT Green/red
Link/ACT X1 Green
Link/ACT X2 Green
142 | Danfoss A/S © 2020.08
Advanced
X1
X2
X3
LINK/ACT
Flash status Description
On
Servo drive is in state Operation enabled
Flashing Auxiliary voltage is applied.
On
Servo drive is in Fault or Fault reaction active state.
Flashing DC-link voltage is not applied.
Fieldbus dependent Network status of the device (see corresponding fieldbus standard).
–
Link/activity status of Hybrid In (X1)
On Ethernet link established.
Flashing Ethernet link established and active.
Off No link.
– Link/activity status of Hybrid Out (X2)
On Ethernet link established.
Operation
AQ262449648484en-000101 / 175R1135