Canon imagePRESS 1135 Series Service Manual page 1444

13) Check the positions of the groove of the drum shaft and the groove of the drum home position detection fag.
NOTE :
The process unit can be fitted into the
host machine by aligning the groove of
the drum home position detection flag
with the groove of the drum shaft.
NOTE :
If the groove of the drum home
position detection flag is aligned with
the groove of the drum shaft, go to
step 16).
If not, go through the procedure from
step 14).
9
Installation > Installation > Installing the developing assembly
14) Take note of the following points when fixing the process unit.
CAUTION :
When turning the drum, be sure to
turn the drum counterclockwise.
(The drum surface can be
damaged if turning the drum
clockwise.)
9 Installation > Installation > Installing the developing assembly
9-27
F-9-59
F-9-60
9-27